Windspill Deluxe Adjustable Basic Kit Specifications

  • The WINDSPILL DELUXE ADJUSTABLE “ BASIC KIT” has two Base castings and two Arm castings. The Base castings strap to the light pole. The Arm castings each have a 13/16" fiberglass rod epoxied into them to support the banner. Included are four 3/8" wide x 1" long self-locking bolts to secure the Arm Units to the Base Units. A "Kit" will install a banner top and bottom hem - banding is NOT included  - You can order banding separately HERE. (COMPLETE KITS include Quick-Release Banding and Cable Ties)
  • Two kits will install two banners, one on either side of the pole, sharing the same banding.
  • Heavy Duty Construction: Cast of aircraft quality 356 aluminum alloy, withT51 heat treatment. All rust-resistant components.
  • The 3” width and the 7” length of the Base Unit provide lateral and vertical stability for the system. It fits round, square (up to 5" wide), octagonal and fluted poles over 3 1/2" in diameter. It can be lag-bolted into wooden poles or flat surfaces.
  • The Base Unit does not require a confusing “top end up” mount as with some systems on the market. It doesn't matter which end of the Base Unit is up or down.
  • The Base Unit allows the Arm Unit to mount directly to the base unit. Two 3/8" wide x 7/8" long bolts install through the adjustment slots in the Arm Unit and thread into the Base Unit to provide a strong, safe bond between the two castings.
  • Banding guides on the Base Unit allow up to two wraps of 3/4" wide banding to secure it to the pole.
  • Two 13/16" diameter unidirectional solid fiberglass rods are epoxied into the Arm castings to provide flexibility while maintaining strength. The canted rod design keeps the banner taut, yet absorbs the wind energy to reduce stress on the banner and the light pole - up to 25% wind-load reduction.
  • Easy to install and maintain. Up to 3" of length adjustment for proper banner tensioning.
  • Convenient banner tie-down on arm unit for securing your banner.
  • Banner Arms can be installed or removed without disturbing the main (Base) casting.
  • Safety features built in. No additional safety or lynch-pins are required. No moving parts to wear out or fail. Two 7/8” long by 3/8” diameter self-locking bolts pass through the adjustment slots in the Arm Unit and thread into the Base Unit. The Arm unit cannot be separated from the base unit unless both bolts are completely removed. The self-locking bolts are very easy to access and work with. THIS IS THE ONLY BANNER BRACKET SYSTEM ON THE MARKET WITH THIS PATENTED FEATURE.
  • Stock sizes for 24", 30" and 36" wide banners. Custom arm lengths available up to 36".
  • The Deluxe Adjustable will support up to a 36" wide x 96" long banner, top and bottom hem.
  • Twelve Year Warranty when properly installed and maintained. 
  •  Standard Packaging: 4 kits per carton
TOP